From Wikipedia, the free encyclopedia
A tone contour is a tone in a tonal language which shifts from one pitch to another over the course of the syllable or word. Tone contours are especially common in East and Southeast Asia, but occur elsewhere, such as the Kru languages of Liberia and the Ju languages of Namibia.
[edit] Themes
When the pitch descends, the contour is called a falling tone; when it ascends, a rising tone; when it descends and then returns, a dipping or falling-rising tone; and when it ascends and then returns, it is called a peaking or rising-falling tone. A tone in a contour-tone language which remains at approximately an even pitch is called a level tone. Tones which are too short to exhibit much of a contour, typically because of a final plosive consonant, may be called abrupt, clipped, or stopped tones.
[edit] Phonetic conventions
There are three phonetic conventions for transcribing tone contours.
- Diacritics such as <â> and <ǎ> are used for falling and rising tones; diacritics for dipping and peaking tones, and well as distinguishing between lower and higher rising or falling tones, are not widely supported by computer fonts as of 2008.
- Tone letters such as mid level <˧˧>, high falling <˥˩>, low falling <˨˩>, mid rising <˧˥>, low rising <˩˧>, dipping <˨˩˦>, and peaking <˧˦˩>.
- Numerical substitutions for tone letters. The seven tones above would be written 33, 51, 21, 35, 13, 214, 341, for an Asian language, or 33, 15, 45, 31, 53, 452, 325, for an African or American language. This is because the Asian numerical transcription is an ordinal scale based on fundamental frequency (f0), while the Americanist numerical transcription is an ordinal scale based on periodicity rather than frequency. These two properties of the signal are inversely proportional to each other in terms of their mathematical relationship.
[edit] Characteristics
Contour tones contrast with register tones, where diacritics such as high <á>, mid <ā>, and low <à> are usually sufficient for transcription. These are also used for high, mid, and low level tones.
[edit] See also
